MIKROTIK - MLAG By CLI

From wiki.1001solutions.net
Revision as of 14:22, 21 January 2023 by Z (talk | contribs)



Configuring MLAG via CLI

To configure MLAG via CLI on a Mikrotik router, follow these steps:

1. Connect to the Mikrotik router via the CLI.

2. Create a new bridge by using the command:

/interface bridge add name=bridge1

3. Add the ports that you want to aggregate to the bridge by using the command:

/interface bridge port add bridge=bridge1 interface=ether1 /interface bridge port add bridge=bridge1 interface=ether2

4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command:

/interface lacp set [find where bridge=bridge1] lacp-enabled=yes

5. Verify the configuration by using the command:

/interface bridge port print