MIKROTIK - MLAG By CLI
From wiki.1001solutions.net
Revision as of 15:21, 21 January 2023 by Z (talk | contribs) (Created page with "Category:Post-It == Configuring MLAG via CLI == To configure MLAG via CLI on a Mikrotik router, follow these steps: 1. Connect to the Mikrotik router via the CLI. 2....")
Configuring MLAG via CLI
To configure MLAG via CLI on a Mikrotik router, follow these steps:
1. Connect to the Mikrotik router via the CLI.
2. Create a new bridge by using the command:
/interface bridge add name=bridge1
3. Add the ports that you want to aggregate to the bridge by using the command:
/interface bridge port add bridge=bridge1 interface=ether1 /interface bridge port add bridge=bridge1 interface=ether2
4. Configure the ports as a LACP (Link Aggregation Control Protocol) port by using the command:
/interface lacp set [find where bridge=bridge1] lacp-enabled=yes
5. Verify the configuration by using the command:
/interface bridge port print
</nowiki>
